Traction control

Hey, i have. 2013 tacoma and i have 2 buttons , one is rsca and traction(with the little car logo) how do i take everyting off properly so that everything is off?
Prob not is right section but i have no tow/haul button like my thundra so whats gear do i use to pull a trailer?
Thx in advance for your help

 

The owners manual in the glove box should explain the 2 buttons. As to what gear for towing normally you would leave in over drive unless it starts down shifting (back and forth) a lot then drop down a gear. Going up a mountain for example put in a gear that maintains a steady speed and RPM.

 

RSCA = Roll Sensing Curtain Airbags

To turn off VSC / Traction Control :

At a stop , push and hold the VSC ( car with burn out lines ) for 3-5 seconds , this will illuminate the AUTO LSD and VSC OFF lights , continue holding the button until the AUTO LSD light goes out leaving only the VSC OFF light illuminated

Pushing the button again re-activates the VSC system as does turning off the truck

 

When u say overdrive u mean 4th gear or d position cause i saw a couple of thread that said never put it in d position when towing because its too hard on transmission

 

Use D unless the tranny is hunting for gears , if so , use 4th

 

Thanks