Long Travel BS Thread

Yeah but good luck finding one, I've seen like 1 or 2 that wide ever.

 

Hmmm expensive but my work has a national account with Jasper, and we use econoline rear ends

 

Or order a speedway housing, you can get them any width and the are very reasonably priced. But keep in mind the housing is the cheapest part of going to a 9".

 

Question for you! I have that set of PRP seats and several sites show that there are mounts for my truck but PRP is saying they dont make any for it... The sites all show 1995+... Any info?

 

True! haha

 

Now that I have no idea ha never mounted racing seats without fabbing mounts

 

i heard the only company making brackets for 2nd gens is corbeau
http://thmotorsports.com/i-172594.a...type=pla&kw=&gclid=COWqkvWGtboCFc41QgodFR0AGQ

 

Its been a long process but finally starting to work on the Tacoma again, should be back on the road in the next few weeks, planning on using it for a little while the weather is nice then chopping the frame at the bumps early next summer for a more functional back half.

 

Your forgetting spindles. I believe the custom Solo Spindles that come with that kit are wider as well.

 

Does he have/is he getting solo's kit then? I just assumed the 4.5" over included the spindles. I'm not 100% on this but I think solo's kit, spindles and all, is around a +6 to +6.5 kit.

 

Its going to be close to right at 90" trackwidth with 4.5" BS rims...

Not Solo but American Motorsports.

 

ok. I was trying to figure out where Monte was getting Solo from. haha Pretty sure it will be almost impossible to have a track width under 90" with the Solo kit, maybe if you were running 235's on skinny rims. haha

 

i was refering to you. Thought you were talking about your own plans and i was saying the Solo kit is wider then 90'' haha

 

I see. Nope. I am not planning on swapping out my rearend for quite some time. Probably won't do it unless I link it.

 

can you measure the mounting feet on the drivers seat? Im trying to see if they are the same as an 05+...

 

the mounting of my stock bucket seats? sure. Haven't pulled both seats before though i cant say that the brackets are designed very differently..

 

Are you saying they are different or not?

Yeah just the stock mounting locations... ANd maybe a picture of the front and rear feet?

 

yea the brackets mount differently. Ill got get photos.

But the distance from the front left to rear left is about 17.5-18''

front left to front right is about 17.5''

give or take a tad.

The rear right mount though is what is different if i remember right. On a 1st gen it mounts side ways to the tyranny tunnel. I don't think this part is the same on 2nd gens.

Ill got snap some photos.

 

The piece on the inside of each slider?

 

yea similar to that. I have photos. Just gotta upload em. I took a lot for you.