What Have You Done To Your 2nd Gen Tacoma Today?

I put leather protectant on my Katzkin leather seats... It's "greasy" looking at first, but eventually absorbs.

* and yes, it's apparently 2-tone... Didn't know myself until I started with the protectant.

 

^What leather conditioner do you use? I used Meguiars when I had my Mazda. Now I use the same for the Taco's steering wheel and shift knob.

 

Nice!

 

I'm suprised that fits in that cubby , did you have to do any alerations to the plastic bin ?

 

Cleaned and pimped ready to go.

 

Finally took her off the pavement and went shooting in the desert.

 

Got my CBI tire rack installed today:

 

Ordered a Toyota flip key fob blank. Going to try and cut the case to fit the transmitter inside. Immobilizer chip should be standard fare. Will start a thread if it works well.

 

Wheelers Off Road Kit, Bilstein 5100's @ .85, Eibach 620lbs., 1.5 HD AAL 3 Multi-Leaf, 3 Deg Shim, CB drop,

Front 34" to 37", Rear 36" to 39"
I am sure it will settle down in a few weeks...
( was trying for F-2.5", R-2.0", but got 3" all the way around!!!

 

I finished fabbing up my homegrown bracket for auxiliary lights and mounted a pair of Hella 700ff lights on it. Also just realized I need to swap out the front sway bar links. Got a little clunk under there and I can feel a slight bit of play in both.

 

That rack is sick. Does it bolt into your bed rails or what?

 

how much the kit cost

 

Thanks! Yeah it bolts right into the rails, 4 bolts each side.

 

Replaced the reverse lights with something brighter. Re tightened the roof rack bolts, changed the brakes on the front, changed the oil and found out there is no fuel filter? is that correct? And changed the air filter.

 

The fuel filter is in the tank, isn't it?

 

Made a AR-15 shift knob, plugged the top hole and poured fiberglass resin w/ liquid hardener into the base to fill it up. Once the resin hardened I drilled a hole with a 17/64ths drill bit. I was able to then thread it right onto the shift shaft and it is solid.

 

Yes it is

 

had lsk install my limit straps and bypasses today

 

Ryan, that looks awesome!

 

Thanks! And thank you for serving!