Long Travel BS Thread

quick question, anyone know if engage is having a black friday sale? im looking to pick up some leafs if possible.

 

they always do, normally comes out a week or so before.

 

so what do you guys think about this? on each side the bushing is like a 1/8th inch out of the shackle pivot.

also check out my shackle rubbing my frame on the inside way worse than the outside.

can i just grind down my frame right there?

 

king 2.0 8 inch tripple bypasses for $600

http://www.dezertrangers.com/vb/parts-accessories/211837.htm

 

Are the shackles bent? Have you tried using something like delrin so it can prevent the shackles flexing like that?

 

no the shackles arent.

and no i havent, but when im flexing the suspension out, (stuffing 1 side and drooping the other) isnt it going to flex like that no matter the bushing?

 

i wrote on there fbook wall asking earlier this week no response yet...im thinking there probably at the baja tho

 

Not if you have delrin on the top bushing pivot

 

Yes they are

 

looking for ideas on coil size and rates for the rear of my single cab. 22 gallon cell behind cab, 2 33'' spares. 14" 2.5 coilovers.

 

Anybody got some 2.5 ,16" triples to sell ..

 

you ask this guy?

http://www.tacomaworld.com/forum/1s...king-smooth-body-shocks-fox-bumps-w-cans.html

 

No bypasses only. Dont want smoothes

 

my bad, thought they were i need to learn how to read again apparently..

 

im sure you have looked, but might wanna try rdc? im looking for 8s and was only able to find doubles

 

Yeah i did, found three oohs but i dont know if i wanna spend so much

 

http://www.dezertrangers.com/vb/parts-accessories/211837.htm

 

nothing smaller than a 2.5


ideally id want a 3.0 but those are never used.

 

Saw these this morning, I am RoadRunner over on DR...

You don't want them Hiatt, haha

 

1st gens.....how r u guys securing ur brake light housings when u r running fiberglass bedsides? I drilled small holes and tried reusing the screws and coarser ones....didn't hold. Possibly epoxy a nut on the back of the glass any ideas