IronMan 4x4 2" lift!

I'm diggin' mine but it's only been on not even a full week yet

 

That was gonna be my next question. Haha I know it'll be stiffer but I drive A LOT for work so I don't want anything super bouncy and sloppy or like a rock. Is it really that much stiffer than a stock TRD/bilstein setup?

 

Got about 2k on mine and zero complaints on or off road. WAY better ride than stock.

 

Any of you guys have the front settle more than the rear? Driving it this morning feels like I have a ton more rake then when it first went on - need to to get to a level surface to measure it again but it just feels different...

 

Mine sagged about 3/4" on the first 100 miles. I'm right at 22 3/4 on both sides up front and it hasn't changed in a few thousand miles.

 

The rear sagged on mine more than the front... Well, unless you count my coils that were improperly installed and bent at an angle first. But no, the fronts are still in great shape. Minus no powder coating really on them.

 

I think mine sagged about the same as 4lo's - anyone running the top plate spacers and if so how do they feel? Really wanted to avoid spacers but thinking about putting some on, the rake is really buggin me.

 

Mine are measuring about 22 1/4 on the front

Ordered the 3/4 top plate spacers, hopefully that's as far as they go.

 

Did you install the spacers?

 

I mean the spring spacers that come with the lift... That go under the spring.

 

Had them installed by toytec, came as one piece and just swapped out the old with the new - any way you could put a pic up so I can make sure they put them on mine?

 

This kit has been ordered

 

Congrats. I love mine

 

More people into the club!

 

How many miles do you have on the kit now? How many months has it taken to get there?

 

I have over 10K on mine now, not sure on time frame.

 

I had 4k on it on my first truck, swapped it over to the new one and I think this has about 10k. So, 14k total after 18 months. Had some hiccups in the beginning but they all worked out.
Took me a little bit longer than it should have to get to me. Long story, mainly dealing with SierraExpeditions in Arizona who I bought it from and Camelback4x4 in NJ.

 

Did either of you guys use the spacers they sent under the coil seat

 

Yep. About 1/2" or something like that? I have them on both sides. I DID ask them to start adding a 1/4" poly to one of the sides to assist in lean, but I don't think they ever did.

 

Yup thats them, I used them also and they hadnt added the poly when i did mine