BAMF Sale next week anybody want to split shipping

can you guys send me your order number. Just got a replay from Jerry need to use order number don't have TW member names on the order.

 

PM sent. Thanks for taking care of this for us.

 

Dose he make roof racks?

 

No, but you can check out his website http://www.bayareametalfab.com
If you are looking for a roof rack check pelfreybilt website Tyler makes some roof racks http://www.pelfreybilt.com/#!roof-racks/c1e6h

 

Here's an update jerry got the order numbers and said the sliders are starting to be built and but there is no ETA on when it is going to be shipped out.

 

Thanks for the update. I won't even get to Hawaii until July, so the wait isn't as bad for me as it is for you guys.

 

Some thing to look forward too other then paradise.

 

Yep.. the crappiest part is the waiting game.. But then again, I need some time to save up for the Pamalu or whatever I'm gonna coat it with..

Anyone ever thought about dipping (galvanize) then spray?? Just asking..

 

Hot dip galvanizing will make the metal more brittle. We use a zinc primer from sherman williams that works pretty good on military vehicles, but putting that on sliders or bumpers that you intend to use is way overkill and pointless IMHO.

 

Overkill??? Isn't that half of us on here... lol... (at least some of the guys here.. No offense.. just a bit of jealousy..lol)..

Zinc primer first it may be!!.. ha..

 

If you do, wear a respirator. That stuff is really bad.

 

I think my coworker did that for some stuff.

got me a respirator to do it myself next time

 

Any news on this out of curiosity

 

Nope usually 5 months so that would out us at March April time frame.

 

neighbor was telling me about POR15 as a possible undercoating. Any insight on that vs that zinc primer before rattle can or sending it off to pamalu?

 

Im thinking just going to do rattle can. Pamalu is nice but my skid plates got it and it is peeling off. Looks like they did not prime it before putting the liner on. POR15 might be the route before taking it down to pamalu for coating.

 

Was reading somewhere that POR15 is light sensitive and may look bad if exposed all the time.. I may rattle can, but do some type of bottom layer.

 

Was reading some post from JLEE looks like the November orders of sliders will be done by the end of February.

 

Yep.. I was just on the BAMF site over the weekend and saw that they are now back to doing full top plates on their 96" sliders... (at the time, they weren't doing them anymore). Kudos to Jlee.. Sent him a PM, paying the difference and getting full top plates.. At least my wife won't give me (too much) flack.

 

Paint won't stick very well to POR-15. Also, POR-15 doesn't work well if there is no rust and has been found to allow rust to form underneath it when painted on clean metal. It's advantage with rusty metal is that it soaks in and then seals the rust preventing it from corroding even more. I have it on parts of my frame, but most of the metal I welded to it did have a thin layer of rust from sitting outside. It's hard to take off without a grinder.