What have you done to your Tacoma today? 1st Gen Edition

Haha nice!

Stalk away

 

How did you wire the halos to your running lights

 

Just ran the wiring from the halos into the running light wires using wire taps.

 

i drove my truck today

 

Yup. Wish I could do more than drive it thou!

 

work great off road, no complaints here. Wheeled with them on 3 trips, pretty tuff terrain also. But like you said earlier they are a heavy tire... This coming from a guy that is now running a heavy ass 35

 

Shit.. I have some 305/70/16 Toyo mts for sale. They have less than 2000 miles on them.

 

I love TW.

Comments after an awesome mod always resemble something like:

"Dude, that looks so sick, time for...."

And the never ending progression continues.

 

So I just got my BAMF cb mount. Quick question does it mount with the tailgate clip in or do you have to take it out to make the mount fit, I tried to put the mount with the clip and my tailgate didn't shut, any help would be great!!

 

This!

 

The antenna mount should just fit over the tailgate clip allowing it to still latch the tailgate shut.

 

Ugh I couldn't get my tailgate to shut do you have one? Could you snap a pic of it??

 

I have one, but it's dark and cold out right now. I can snap a pic when I leave for work in about 2 hours... Haha

I mounted mine up and everything, then pulled on it towards the driver side to get it far enough away from the tailgate. I have to mess with mine again though because it's rubbing again.

 

Headlights went out on my brothers '98 Tacoma, now only his high beams work. He replaced the bulbs but is still having the same problem. Has anyone else had this issue? Any ideas?

 

Ya if you could get a pic that would be awesome! Thanks buddy

 

I had this happen, if it's the same problem, run a ground wire from the body to the negative pin on the lightbulb. I think it's the center of the three, use a meter to check for current before you pop a fuse. i just shoved a wire in with the connector and attached the other end to a body screw. You only need to ground one light. You should regain both high and low beam but will lose the high beam indicator on the dash.

This was how I fixed mine, I never found the source of the actual problem.

 

Thanks I'll give this a shot in the morning, tired of people flashing their brights and now that I changed my bulbs my brights are even brighter

 

Monte spare me a few lights lol

 

Just bolt it on top of the clip. If it touches the tail gate you can just pull it over until it clears.

 

Like this.


Mine rubs slightly but not bad.