FS: Bed bars

Made by Relentless Fabrication. These were supposed to be 2nd gen rails but dont fit (at least not mine) see bottom pic. So measure your bed before you buy. No dents, just minor scratches.

I prefer cash in person but will do paypal.

**SOLD**

a

 

Pmed

 

Still for sale

 

Bump

 

Where in SD are you located?

 

how much would shipping be to 32433?

 

Clairemont

PM me your address so I can get you a better rate with my company account.

 

hey, i used to live in Clairemont...on Beadnell Way.

um, bump.

 

I grew up on Cannington Dr.

thanks for the bump.. haha

 

bump

 

bump

 

Still for sale.

 

Do they come with any tab inserts to bolt to the factory rails?

 

They come with the factory bolts that mount the bars to the rails.

 

Okay, let me take a measurement in the morning and see if they'll work. Thanks

 

Mine is at 57" also..these are defiantly for a 2nd gen?

 

The guy I bought them from said they came off his 2009 double cab and fit nicely. They work on my truck with some help from a few washers.

 

My truck is a 12 and have the same shitty fitting.

 

OK, so i'm a bit confused here with this... I had a couple guys recently mention a bit of gap so I've double checked my measurements and jig and sent out replacement bars for good measure. Before sending we also test fit them on a '13 tacoma before leaving my shop... They had a maximum of 1/8" play, I would say most likely it was closer to 1/16" as they would barely move side to side between the rails. I built them at 56 5/8 as the measurements I pulled from trucks was always at 56 11/16".
So next idea would be that some of these trucks are manufactured at a different plant than others and that leads to the irregularities?

 

Mine was made in San Antonio bought brand new no wrecks, I had to get longer bolts because after I got it started the other side couldnt even reach to get started. Tried puting it in the center and staring at the same time but they didtn touch.