Idaho BS thread in the PNW

Holy shit haha

My rims are only 4" BS. You'll need spacers.

FUCK no haha not even REMOTELY close.

More inside but also outside. Because at full lock when turning the outer lug comes into the a pillar and fire wall. Quite a lot. That's why you have to cut that part

 

Hey Monte, can you measure how wide your tires are on the truck when you get a chance and try to measure how wide you are from outside edge of tire to outside edge of tire.

Then Mark can meet up with this guy and measure the same by just throwing the front tires on real quick.

 

Dibs! haha


I can't run 15's...

 

Yea I can.

Need to figure this out ASAP. I gotta drive 400 miles extra to deliver these things..haha if I don't have to..be a nicer drive day

 

I know i would need spacers

ok, was just checking. so i want to see how much i can actually turn with these things. i guess all the cutting will be determined by how far they stick out. in this case i want them in a bit more, because i have room to cut inside more, vs getting super close to the door hinge

any other measurements i should take?

good, go away.

thats what im trying to do!!

 

Measure the BS on those wheels! and are they 10" wide wheels for sure?

 

how exactly does one meause that?


and i dont know for sure!








also...this is absolutely beautiful!! love it!

 

Novel idea only moab calls my name and some one out there wants a pair of arb's in some 4.88 gears and they will pay me for it.
Ill get my money back on the arb ill lose my time to install it. oh well..

im lost what do you want dibs on..

 

you fucking derp it's the distance from the back of the rim to the mounting surface of the rim..

 

Mark wants your MTR's so I was fucking with him. haha

 

great now hes gonna measure with some sorta warped peice of cardbord

and yeah i was gonna say what could you possibly use off of my truck for your LT second gen truck you bastard.

 

Better?


Bigger tires haha Can't run 15's on 2nd gens though...

 

Much better and actually there is a guy in pocy that has a second gen and has a set of 38's on 15's he runs. the wheel spacer he runs to do it is retarded though

 

I've seen it! Nothing like having negative backspacing. haha

 

K I figured that's how it was done

 

That was a BAD movie

 

450lbs worth of steel according to the sales receipt...



Those 4'x4' sheets just barely fit in my bed with the tail gate down.



Squat much... I may have to talk to deaver about getting more leafs for this leaf pack... I think once we get the frame plates and the shocks in I will be at factory ride height in the rear or lower...



I took the flare off to see what it looks like under there and so we can see if we will have to trim the bedsides at all for full stuff. I already know I'll have to trim the flares





That damn salt is already making the bedsides rust where the paint chipped off of them...

 

Are you building skids too?

 

No. I already have skids, and yes I may have bought a bit extra steel... haha

1 sheet if for building the shock towers and the other is for plating and boxing the frame. Depending on how much steel I have left over I may just plate all the way to the front.

That smaller sheet on top is the new bottom for my toolbox. My hi-lift fucked it up.

 

Mark, since I know you'll check this thread before anything else. Dinner tonight, Myself, you, Jordan, Zach and Myles are a maybe.