Colorado B.S. Thread

Thanks! Haha yeah as we put it on I was like "I think that emblem is going to be dead center ha" and it is lol. We turned it on and it was like BLUE! it doesn't appear to create any shadows from what I saw on the wall like 3 feet in front of it oddly enough lol

Pervert. Definitely! We still have to run a switch to it but I think that's on the list for tomorrow.

 

Got hyped when I saw the Alcans in the driveway!!!!!

 

For rotations I've always followed the "cross the non-drive tires" method.

 

Who wants to drink a bit fri night before I leave? Sorry I haven't been able to see some of you guys. I leave Saturday. I'll be at cheapskates off Parker and Yale around 7ish so a bit early. I'll also be in golden to hit a few breweries tonight.

 

i rotate every oil change and swap sides on the front and rear. Then the next time I swap front to rear and so on...that way every tire is in each position the same amount of time.

 

put it up on stands so all fours are off the ground Kyle?

 

I was bored and trying to find my truck on Google street view (I think it was in the garage at the time) but I found my dad's trucks. I got so excited because it's rarely outside the garage and what are the odds it was!



It blurred out the TRD too haha! Can anyone else find theirs?

 

My dads old car is out in front of my parents house.

 

anyone know of a good place to do a cmc in the south metro Denver area?

 

Only when moving the fronts to the back. otherwise I can just do the front and rear separate.

 

Cmc?

 

Cab Mount Chop

 

Is that so you can run wider tires?

 

Si.

 

How wide can you go with this? My buddy needed to do this to his truck but didn't know it. He thought the rubbing was due to his lift, he spent a ton of money and time trying to figure it out. Finally he was like F it and just dealt with the rubbing. I haven't gone over 265/75 R16 for this reason.

 

How wide would depend on your specific lift, tire style / width, and rim and or wheel spacer setup. So its hard to say exactly...but it will def help as its the main rub spot on these vehicles. I want to get it done, just need to find someone who will let me use there welder.

 

Hey Guys. Does anyone know of a place that will tune my Tacoma? I have a S/C with 7th injector (and a whole lot more) and since moving to Denver, my truck is running like the pooh. I've done some searching and sent a half dozen emails, but have no responses yet.

any suggestions would be appreciated.

 

sorry i dont know one. I would think any "tuner" shop could help you out. If you were in Socal I could help you out more.

 

Thanks Redline. I'll keep checking around. I dropped the crappy piggyback that URD gives you with their 7th injector for a unichip piggyback. I think that telling people this has scared them away.

If Socal as 5280 ft, I might take you up on that. I'd settle for a tune at a comparable altitude right now...even if the temp was Socal like.