Calling all Virginians (Tidewater area)

Like that Jeff Gordon test drive video

 

We test drove a burnt orange MT.... I was chirping everywhere! We ordered ours as an auto and never looked back. As a daily it does awesome and it so much better than the mini copper she had before! If it was only a little weekend blaster it would have been a stick but I do enjoy an MT.

 

Not quite that bad but he was tapping around the interior looking for the oh shit handle and bracing himself with his other arm.

 

my truck has been payed off since 07 so i havent had a car payment in 5 years. and now my payment on the car is barely over 300 a month

 

Truck is not a factor after this month but still didn't want to spend that much. Oh well, Corolla gets me to work.

 

Damn, that's a great idea, would work nicely with the HC bumper. I'll have to go this route if I have heat issues. I really think the cubby can handle the weight (#20) with no issues. time will tell though.

 

Great morning to play in the snow

 

I have your rc clips

 

Thief!

I'll grab them from you whenever, I still haven't fixed my drive shaft issue. Anyone want to buy a Axial SCX10?

 

Too bad the state wont let you near kids...

 

shhh, not so loud, they will hear you!

 

Hmm both have red trucks, both spend a lot of money on hobbies, both sell the shit quick, just saying we might have two Jakes in our midst.

 

Compressor is already in the cubby and the 5 gallont anks mounted just have to finish running wire and air line.

The RRP solid 1 piece diff doesn't have holes for the pins, and the damn set screws I got aren't holding the axle to the diff. Keeps falling off. Probably has something to do with trying to install it in 20* weather while at Shoe Creek. Still need to install the rest of my 4 link too. Too many projects, not enough time

 

Well if that is the case then maybe I will be moving out to VA in just the right time!! start eyeballing what I need!

 

Easily confused ehh...

On the Stock gear, the shaft has a hole, for the long set screw pins that hold the driveshaft to the output shaft. On the Robinson Racing Solid one piece, no hole so you have to use two set screws instead of the pin that goes through it. I just have to mess with it until I can get them both tightened down evenly.

 

Woot gettin eye surgery done in a little bit

 

Won't the set screws go THROUGH the hole the PIN used to occupy?......

 

The aftermarket output shaft is solid, no hole. So Instead of a pin going straight through the gear and driveshaft I have to put rely on set screws.

Guess its hard to visualize, its really simple just the set screws won't hold it for some reason on the rear shaft, front has done fine.