AZ BS Thread 2.0

When it rains it pours, got accepted to the PhD program at Montana state just after accepting that job.

 

That sounds like fun! I've only destroyed one tool so far my friends lexus had a stuck/stripped engine stud so we welded an allen key to it to get it out

 

I do that allll the time. Then again, I usually slip a pipe over the handle for those PITA bolts. Yay free lifetime replacement

 

Thinking about going...

 

Lmfao!!

And my impact is weak as shit :/ I run it at 110 and it has no balls

 

Sounds like it's time for a new one.

 

I think a pickle fork should do the trick.

 

It's a husky too and it hasn't had a hard life. I prefer using my muscles... It's less headache.

Dead blow on the knuckle. Problem solved.

Dead blow. Because BFH

 

I'm down

 

Put a heat gun to it for a minute.

 

I used to use a big fucking hammer every time. Make sure you put the nuts on backwards level with the stud so when you hit it with a hammer it does not mess up any threads.

Now I have one of these and it is awesome.

You could try that too, I bet that would help a lot. Just don't melt the boot LOL

 

I used a pneumatic hammer when I did my ball joints. It was fun haha like a little jack hammer

 

It probably won't even budge if you throw it off a cliff.

 

Errrrrmahgerrrrd!!! Errrrrrcons!

 

You get the 2.5's and a leaf pack already?

EDIT: looks like you are still running the old pack.

 

Waiting on all pro they are back ordered and I got impatient

 

What part of the UCA are you trying to remove? I'm confused. Pic?

 

Soak it in something like pb blaster or atf overnight then hit it with an air hammer, itll vibrate it loose if you have one

 

OH I thought you had the second gen type UCA


At least you don't live in NE... Look at that salt!