Wyoming B.S. Thread

Tomorrow is Friday haha

I don't care you have no bumper!! Better be here damn it! Haha

 

Not if I don't show up! I currently only go to 2 of my classes. It is easier for me to grasp the knowledge from the textbooks and slideshows.

 

So.... I am sending in my UCON back to URD......

 

Really? Why?

Better drive light footed without it..haha

 

Well I sure hope it is an issue with the UCON because we have pretty much ruled everything else out.
My symptoms include rough idle after driving and to keep if from running really rich we have to tell it that I have 720cc injectors in it when I actually only have 600s. He says he has never seen this before and there are other people running the same file no problem. I ruled out the fuel pressure by getting it tested this morning and I did a cylinder compression check this afternoon as well. They are sending me a temp ucon while they bench test mine.

 

Huh....odd man.

Plugged cat perhaps? Bad o2?

 

I haz no cats

 

Of course. As it should be.

Might be stupid..but..did you check the air filter?

 

Yep. Clean. And I was a little bored so ibuffed some casting rough spots on the air box too.

 

You have an ultra Guage?

 

Scanguage

 

Try driving with it unplugged. My dad has a scan gauge too now. But with the ultra Guage it would interrupt the signal to the the Uconn and killed the truck several times..few times while in motion.

 

Oh? Interesting. I may have to try that tomorrow.

 

Yea. But he hasn't told me of any issues since the scan gauge.

 

Worth a shot. I am running the new file as of less than a week ago. This new one is adaptive through all throttle positions not just WOT anymore.

 

Oh bad ass.

Wonder if my dad has that one yet.

 

I think I was one of the first people if not the first to get it and pick through a couple bugs.

 

Well aren't you cool haha

 

Derp. That was supposed to say tomorrow or Saturday. And I will be there! Anyway, I am only limited on time until June. Then I am off for 11 weeks straight. It will be done. And it will be badass.

 

Put the Softopper to good use yesterday. Don't mind the messy fold job. I did it in about 30 seconds flat before work yesterday morning