Maxtrac Spindle Lift for 2nd Gen Prerunners

No.. The spindles are solid. However I see know reason why they couldnt make them for 4x4s

 

Does anyone make aftermarket spindals for the 4x4's?

 

Well put on the 5100s at work a little bit ago now about to install these spindles !

 

No. To explain why:
http://www.tacomaworld.com/forum/suspension/201088-4x4-lift-spindles.html

 

This is probably a stretch, but can anyone please post a picture of Maxtrac spindles with NO preload on the front like adjusted CO's or even raised 5100's. I wanna see Spindles only with stock suspension. And for the rear preferably a pic with a Dakar or AllPro standard pack please. And if I get a pic posted can you please tell me what size tires are on it as well.

My plan right now is the Maxtrac up front with my 5100's set at 0" and then have Dakar 2.75" rear leaf pack with probably Icon 2.0 ext resis and bumps. My goal is to be LEVEL! I DO NOT want to be nose high as all!. If the Dakars make the back higher thats fine I can always remove a leaf or crank up the 5100's still I throw so CO's up front.

Thanks!!

 

So its late and im tired as faaaak but just finished installing spindles. Pretty easy just time consuming. I hate brake lines. But so far I have SUPER bro lean cause I have stock rear. Will change that soon. Will post up pictures tomorrow...

 

Maxtracs up front with stock coils and dakars in the rear

 

What size tires are those? Look stock 32" correct?

 

look like a 16" rim with stock sized tires so probably like 30.5"

 

Yea they are the stock tires and rims

 

And here are the daytime pictures Maxtrac 4", 5100s set at 0; stock rear.
SUPER BRO LEAN....

 

But you said stock year in the above pics. So with a leaf pack itll level right out right

 

You would be probably be tail end higher with the allpro expo pack and most likely level with the dakar pack

 

Thanks! Good info, that's kind of what I thought

 

2006TRDoffroad-- Did those Total Chaos UCA's bolt right up to the Maxtracs with no mods? I thought that I read somewhere that you had to add a spacer or something with the ball pivot UCA's.

 

You said that are using light racing UCA's. What UCA's are you using? Because I have the same as you (2.5" coil overs and the Maxtrac spindles) besides the UCA's, but doing research to see if the Total Chaos uppers will work or not. And do you have a shimmy in the steering wheel while going 50-65 mph.

 

No mods! Bolted right up. Fit like a glove. I know with the first model spindles when they first came out they had problems but its been corrected.

 

They work perfectly. And as a matter of fact I have a shimmy from 45-53 mph. Im tryung to figure out what it is.

 

whats your rear lift. Shimmy at that speed are usually rear lift degreeing and or carrier bearing drop length.

 

I think my carrier may have recently gone bad. Vibes at starting speeds, and then I have squeaking in reverse.