The 2.7L Single Cab Thread

Haha, have fun lol

 

Bout time! Good luck, wont be easy to make look good on a tacoma.

 

Here's a few new pics

From my wife's tuck out crusing the dunes


New rear tube bumper spare tire mount gas can mount and hi jack mount


New front tube bumper


Also threw on some led tail lights just didn't get a pic

All I need now is to do my 35" and some LCA's

 

Just ordered my twin stick transfer case

 

Can't wait to see this. I'd like to do the same.

 

Yes, neither can I.

Going to be such a busy summer working in the truck, hope I can finish everything up so I can actually go wheeling again!

 

Got any pics?

 

Just ordered today lol, I'll have pics once I get it and have time to install

 

You are suppose to do this stuff during the winter! Summer is for wheeling

 

If I had a garage and a working transfer case you can bet your ass is be doing it in the winter!

 

If i put 265/75/16 tires on 16x8 rims, on my stock suspension, will the tires rub??

http://maine.craigslist.org/pts/4412959430.html

Found these and have the guy talked down to 175, maybe 150. good deal or not? he said the lug pattern is 6x 5.5 that's the same as ours correct?

 

Yuck, definitely wet in there. Good luck man, might be hard to track down with it everywhere like that

 

You should be fine I think the trail teams are 16x8

 

Suicide attempt?

 

So i have a stupid question.... a 33.12.50r17 translates to a 317/64/17 when i do the online calculator...i was under the impression that a 33 was a 285 and a 35 was a 315?

Next question is with some trimming of the fender wells will a 33-12.50-17 fit? im sitting on ome884's with an aal in the rear.

 

A 285/70/17 is a 33 but it's just over 11 inches wide. Any particular reason you want such a wide 33?

A 315/70/17 is basically a 35x12.50

 

well a guy wanted to trade for my new atps for his slightly used mud graps. i said no but im still thinking lol i just dont know if they would fit easily. I see some ppl that say they do fit and some say cab mount chop and all is needed.

 

Probably would need a CMC and light trimming. Not a big deal...DO IT

 

I have 285s and haven't trimmed anything yet, I rub the front of the fender well at full lock or under compression but that's it. Haven't rubbed the cab moubt yet.

I would guess with the right backspacing you wouldn't have an issue and even with less than ideal I doubt it would be necessary to cut the cab mount. It's the same height as a 285/70/17 just wider.

The mud grapplers are supposed to be a badass tire too, post pics when you swap