PcBuilder's 2003 Tacoma Build

Ah, should be a foot.

 

That's it? Mine pretty much fills from wheel wells to cab. Trying to make sure my bed rack will fit between cab and toolbox or if I will have to move my box.

 

Mine does too... How wide is yours?

I just cut the corners off of my bed rack rails to allow it to sit a little more flush.

Here are a few pics showing how far mine goes out.

 

The very top is almost 21". That's all I measured lol

 

Don't know, I just went off what it said online...

Ours looks to be the exact same width.

 

I will be getting my bed rack from Eddy (SOS Concepts) he uses 1.75 tubing. You think there is enough room fit it? Being as, yours is 1.5"

Thanks for the help Brent!

 

I still have a decent amount of gap between the cab and the tubing, so I think it'll work out. You'll just have to work with him on getting the whole deal figured out. It will push you toolbox back just a tad I'm sure, but not much.

 

Hey dude I talked to you a couple months ago about your set up just got my lift and tires on what do you think? Look familiar? Haha I went with Same tires and rims as you

 

Very familiar! Looks good!

Reminds me of what mine looked like unmolested... Haha

 

No dude your truck looks legit!! Did you have to do the pinch weld mod? I have some rubbing going on I have already done a good amount of trimming its barely rubbing when I'm @ full cut in reverse or when I'm full cut and hit a decent bump its been driving me nuts I want to go burry it in some mud but don't want to destroy my tires! Some people say pinch weld some say wheel spacers but I don't see spacers helping. Any input would be appreciated

 

Here's all I've done.

http://www.expeditionswest.com/equipment/tacoma/bfg_mt_km.html

Also, you're alignment could factor into it. If I have more positive caster I don't rub much at all.

 

Anybody happen to know which seal is supposed to be replaced with the wheel bearings? All I can find is inner and outer, but no specifics on which one pertains to wheel bearings.

 

Pretty sure its the outer, but they're cheap ought to just do both while you're in there. Also hope you got a heavy duty press

 

X2 I replaced mine two weeks ago, it was a pain in the rear. I have a press but I still had to cut the collar off of the berring to press them off. I used a dremel with a cutoff wheel, then I had to buy some thick wall 2 inch pipe ( the most costly part of the job) to press the collars. on with.

 

Thanks, I'll go ahead and get both then.

Not doing them myself haha

Also, need to get the truck on a lift to make sure it is in fact the bearings and not the tires causing the roaring sound before I buy anything.

 

Pussy

 

It was the dealership that changed your oil last time, right Jessie?

 

I can't sleep.

 

Ha

 

looking good Brent