Clock Spring Wires Replaced, Light still on!!

So I ordered new wires, replaced, no visible damaged to to the tape wire or anywhere. Did the clearing of the code, light still on. Brought it to a friend with a Code reader and he tried clearing the code, still came on. Whats my next step?? It's the driver side he said!!! Is it the seat?? I looked and connectors under seat, they are all connected.. Where to next???????????

Need some help!!

05 PreRunner TRD Sport

 

Today I took driver side seat out to check wires and connections, cleaned up the little board where seat beat clips into. Put it back in, crank it up, clicked seat beat, light went off but came back on!!! WTF!!!!!

Whats next, any advise will be greatly appreciated!!

 

What code?

 

B1801 Open in D squib circuit

 

i was wondering if you happen to still have the part numbers for the clock spring wires?

 

Did you try replacing the entire clock spring/spiral cable?

 

Umm....you realize there is a recall for GEN2 Tacoma's regarding the airbag system.

http://www.autotrader.com/research/...ta-recalling-nearly-500000-tacoma-pickups.jsp

Check your vin against toyota's site.
http://www.toyota.com/owners/web/pages/resources/recalls

 

No mine needs to be replaced because my airbag deployed and the connections melted into the airbag

 

Did you have the SRS ECU replaced or rebuilt? if your air deployed, your seatbelt prolly needs rebuilt as well.

These thing are all parts that have to be dealt with when an air bag goes off.

 

...okay, good to know.
You will also need to replace any seat belts was used during your accident.
Seat belts are a ONE TIME USE, because of the loads inflicted during a crash.
Also check the shock sensor...good luck.

 

i had no clue i had to replace the seatbelts too, i have been driving with the same ones since i bought my taco. i will look into that for sure

 

I use this company to rebuild seatbelts and reset the ECU. Very fast turnaround.

Myairbags.com