What have you done to your Tacoma today? 1st Gen Edition

Here are those pics, didn't know I could do this from my cell.

 

Nice 5 lug

 

Thanks, she's my baby. Comes in second to my girlfriend. Haha

 

Got a productive morning ahead of me.

 

After almost a year of putting up with a dash light out, finally swapped in some blue LEDs





Silly me thought there was only 2 behind the A/C controls, but it gave me an idea. Since the middle knob is colored differently anyway, leaving a white light there could end up looking better than having the blue mixing with the other colors. I tried scraping off the orange stuff on the back of the panel only to scratch all the way through the thing, so I will be ordering a clear 4runner A/C panel

 

That Looks Good!

 

Damn. Kids do as I say, not as I do. Lube your u-joints

 

sweet jesus. Glad I did that recently.

 

How hard is it to do the carrier bearing?

 

Took me about 30min. Take off the rear driveshaft and put it in gear and take the nut holding the flange to the bearing. Unbolt the bearing from the chassis and slide it out. Reverse the process for installation. Make sure you get a new bearing bolt because you have to dent it into the flange so it won't loosen up.

 

The ETC button on only changes up-shifts are far as I can tell. It will delay when the up-shift occurs. I think I have read that if at a given load the normal (button off) up-shift occurs at 2500 rpm, having the button on will push that out to 2700 or 2800 rpm.

FWIW, I run with the ETC button on all the time. And have done so for years. At least the last 50K miles. Ever since I went to larger tires. If it was going to bad for the trans, I think it would have shown up by now.

 

Not going to run a snorkel. I'm in the process of rerouting the intake somewhere where I can keep as many of the benefits for dust/water that I had with the snorkel, but it won't be quite as good a location.

 

very nice!

 

Thats sex right there!

 

Yeah that's a gorgeous action shot.

 

x2

Rims mounted and balanced today

 

"Ordering a clear 4Runner a/C panel" - What year and from where? I'd like to do that to my truck too. Thanks.

 

Selling a few things...

http://www.tacomaworld.com/forum/1st-gen-tacoma-marketplace/334134-fs-shocks-coils-shackles.html

 

Yup i need to do this so bad.......so can you a notice a difference after? BTW ur truck looks sick, very clean!

 

there is a torqueing process when you put the stake nut on. Wanna check the FSM or a Chilton's/Haines but from memory:
1. Torque stake nut to 138 lb/ft
2. loosen stake nut
3. Torque stake nut to 52 lb/ft

There is also something in there about making sure the carrier bearing center is aligned to the mount. I re-used the spacers that were on the shaft and hoped for the best.