What Have You Done To Your 2nd Gen Tacoma Today?

Technically haven't done them yet, but I just received these beaut's today

Fox 2.0 Air Bumps, just waiting on the fabricator to do them up.

 

You are in RI. I thought that would be a given.

 

Yeah, I didnt try that though.

Nice. I wonder if it is a known issue though. Usually there is some kind of tsb or something for known issues.

At least im not the only one it happened to when it was cold

 

Got my light mounted

 

Looks clean.

 

Dielectric grease is probably not the best idea in this application. It could cause connectivity issues. Silicon is an insulator material.

I do use it for connectors that could be exposed to water, but only on the seal and not the terminals.

 

where did you put the horns and trans cooler?

 

Did an oil change.

 

The horns went on the bottom of the cross section. There are two bolts there that i used. The trans cooler is right behind the bar. I can snap a pic in the daylight tomorrow if you like.

 

Would like!

 

Did you leave the wire from the bar run over the top like that?

 

Drove up above Treeline to cool off.

 

buzzzz........pop!!!

 

Drove it to work with a big smile on my face like I have every time! Tell I get to work, then it depends on how the day goes till I drive home again!

 

Finally got around to installing the bumper

 

Purchased a bed mat, bed extender bracket mounts, and the parts to relocate my real breather.

 

Cleaned most of the nasties out of the inside. Washed it. (Don't know why.) Put on my "TacomaWorld.com" decal that Lisa gave me.

Bob

 

Pretty productive day!

Fog light anytime mod



Then fab'd my fuse box mount



Hope to wire up everything next week along with some bed lights

 

Was my setup used for yours?