Rampage LED lights ON SALE 7/1-7/15

Thanks for the order!
The roof mount brackets are sold separate, but are listed within the Rampage lights category and therefore the discount works on them as well.

 

Thanks for the info...I did not know that, so I went back and ordered those as well..

 

Question: Any idea if they'll make light covers for these?

 

How are guys mounting the 50's on the roof using the brackets? Do I cut the weather stripping? How is the wiring routed?

Thinking heavily on a 50" radius with brackets.

 

Think fast brother! The sale ends soon!

 

Perhaps some close-ups of the mounting points would be nice for the viewing audience...

 

After doing some research it appears the double cabs already have existing holes in the roof and I can route the wires through them and also the brackets mount to them through the weather stripping. Win.

 

I'm hoping that because it's a single bolt on the light bar, it won't droop if it hits a bump? Front heavy. I know Rigid is building a double mount point to ensure that doesn't happen. Guess you could tighten the hell out of the bolt and use a lock nut...

 

Did you find pics? or just textual information?

 

No pics just researched on this site. I'm curious of the bolt size.

Ordered btw

 

Nice!

Make sure you order the bracket! Comes separately...

 

I read this thread before ordering. Thanks for the tip

 

No worries...I F'd it up thinking it was included...lol

 

Whoa dudes. We use the pre-existing M6 threaded riv nuts that are in place from the factory on double cabs. There are two on each side, thus eliminating the up and down movement you are worried about.. As far as wiring is concerned. I've seen people drill and run it into the cab, or run it down in between the windshield and A-pillar (which is what I did, and we at relentless prefer whilest installing.) our brackets are completely different from other manufacturers.., mainly, ours requires NO cutting of the weather stripping, only drilling of the holes to fit the PROVIDED stainless M6 bolts.

Once again, PM with any and all questions. I am currently running the rampage 50" radius, but have beta tested the straight 40, as well as the radius 42" with our brackets.

 

This picture shows how we utilize the (2) factory mounting locations on each side.

 

Also, as far as the light bar itself, I've had ZERO issues with droop using it's single per side mounting holes. Just use the supplied Allen wrench hand tight and you're good

 

Thanks Nathan for the info...I'm sure I'll/We'll be pleased.. We were running amuck without any expertise in here for a while...lmao!

 

Absolutely no problem!

 

Nathan...I do have one other question. What's the backlog look like in getting these? I saw quite the list in the previous thread.

 

If you ordered the 50, that'll go out Monday, if you ordered the brackets PCD, they will ship ASAP. Usually we see a week-two week turn around from our powder coater.