Heavy Duty 4WD Knuckle.....2nd Gen

Who builds one? I've been searching and find a Pre-Runner ones but not any for 4WD.

Can you install one like the Fabtech without the rest of the lift? Seems like it would eliminate the need to replace the UCA considering its extended and would level the UCA back closer to stock.

Thanks
Bill

 

I think we had a couple of vendors gauge interest but not enough people comitted, as far as I know no one but I'm sure if that chages/changed someone will chime in.

 

I emailed a company that was offering them but no response. I'm calling Fabtech today to see about running just their knuckles.

 

any luck on that one?

 

Best bet is to go with some Total Chaos Spindle/Knuckle Gussets

 

Ive Been asking vendors at SEMA for Years. No one shows interest.

 

Geometry is way off according to Fabtech

 

Thanks Dan, probably the route I'll have to go. I like your company so much your sticker is in my kitchen