What have you done to your Tacoma today? 1st Gen Edition

Got rid of my TG turn signals and did the blinker re locate mod. I was getting tires of the extra wires hanging out. It looks so much cleaner now. I had to go back to some old tinted clear corners I had because I cracked my current corners lens trying to drill the holes. I actually like the looks of these now.

Before:




After:

 

I like it!

 

Thanks! You were the one that first gave me the idea in my build thread! I really should have did this in the first place.

 

Eric just sent me this picture. Can't wait for it to get here!

 

Scored a set of new timbren bumps on CL for 80$

 

Anyone know where to source an Aisin hub assembly? Just worried my front end noise is hub related, although 4wd works...

 

I believe for first gens the whole hub and spindle are one unit, just FYI.

You can probably get one on rockauto, but my guess is it's gonna be spendy.

 

Just the lockout hub...

 

Ah, manual hubs... carry on..

 

Here is the only link I can find for Tacomas..
http://www.offroadsolutions.com/products/aisin-hub-lockout-kit/

Anyone know another option? I would only need the one, if that is it at all...

 

Mocked up the tire carrier today. 35 looks giant on the back of the ttruck.

 

Dayum man! That's pimp

 

Yea out here cause they rust.

In wyo. That's cheap.

Thanks man. You will love it I am sure!

Yes but it's cool but say good bye to rear view mirror...least most of it haha mine is useless

 

So it's been raining here non stop for like 2 days. Anyone know how to take this out? It's on the rear driver doorstep. I took both screws out but the piece is on there pretty tight, don't know if it's a matter of force or what. I don't want to break/snap anything

 

The plastic parts that the screws go into have clips as well. Hard not to break them when removing it

 

Just a matter of force as i recall

 

There are clips attached that , its hard to break it . Take a flat head screw driver and place it under that plastic plate at the end of the plate and pry up , it should pop off . At each place were the screws go in is a clip . Hope I helped .

 

Yep force.

 

That looks killer. Gj.

 

Just matter of force.
I put my palms on the plastic and curl my fingers under the edge inside the truck and just pull with my fingers and push a little on my palms.