Long Travel BS Thread

It needs some kind of tone ring to read off of, i'm assuming that's what he is talking about

 

This is a tone ring. Notice the teeth?

I just need to figure out how many. I'm trying to get it where we can have a full float conversion and still have speedo and odo.

 

Although this is what the front uses:

"The front bearing assembly does not have, or use "teeth" or a reluctor wheel. It uses a magnetic strip and the rollers in the bearing itself for the front speed."

 

This piece...

 

That would be why I never saw any teeth when I had the front apart. Haven't had a reason to tear the rear apart yet.

 

can you try to pull the speed and odo from the trans?

 

The 2wd automatics in both the 05+ four and six cyl have a speed sensor in the trans. I cut the wires to all four wheel speed sensors years ago, and just use the single speed sensor (mine is in the T-case) for the speedo.

http://www.customtacos.com/tech.old...6toyrm/06toypdf/06rmsrc/rm2006ta/02700410.pdf

 

Anybody run this type of boot on their hiems?

http://www.3sx.com/store/comersus_viewItemBundle.asp?idProduct=30365



Also, this is what I was talking about before. Better way to adjust the hiem without taking them off the truck?

 

Looks like double the weak points too me

 

i like the boots..

 

I know its the wrong thread, but nobody's awake in regional lol.

Anyone know if this will fit on stock TRD struts? picking up all OEM stuff tomorrow minus the top hats (guessing he replaced with 5100's and reused the tophat)
http://www.partsgeek.com/gbproducts...nh82hXxGjcjde7tiltquJ4a-YkU9_z_j4HhoC9Uzw_wcB

 

Got all my stub outs to the bedcage finished

 

What rear end are you getting? Also what hubs do you have up front?

x2, but that would make alignment a breeze!

me too

 

Got new tires and race series coil sliders for the truck

 

Hey guys, im selling my king 2.5 x 10" coilovers with extended rod ends, sliders and tender coil. Also selling my king 3.0 x 10" tripples with extended rod ends as well. Bypasses were only used for mock-up and coilovers are slightly used but in great shape. 1000 on coilovers and 1500 on bypasses. 8053049401

 

I'll have to check. They supposedly stopped that on the '09+'s

 

As long as the smaller diameter threaded road was strong enough to carry the forces there no real loss of strength. Just a different way to accomplish the same thing.

My fear is that thing loosening up. Props to whoever made that though.

 

I'll ts just a left hand and right hand threaded bung. Clever, but very simple.

 

Bungs are thick. That middle threaded piece is not. And it's threaded inside and out. I would not trust it.