Apollo 3.0 with LED ring question.

Ok so I know the recommended size is 100mm but I was wondering if anyone has tried the 110 mm in the 3.0 shrouds. The 100mm one seems a touch too small. Anyone had better luck with something a bit bigger?

Thanks.

 

I have both components right now for other retrofits, I'll get right back to you

 

Too big, won't even it inside the shroud.

All the sizes are closest to what works best. The apollo 3.0 is a pain to get the halo centered in but it's not too difficult.

I hope in the future Morimoto makes shrouds with centering tabs for the halos!

 

Thanks for the quick reply, I was thinking 10mm wouldn't be that much bigger, but I guess it is. Thinking about getting some 105mm rings off the bay or somewhere to see how they fit.

 

It just takes a minute and you will get it at the exact right spot. Ya it is a pain and dumb that it doesn't fit right in there but it works. To make it easier, i plugged the ends into my cordless drill battery so it could just sit on the counter lit up while i adjusted the ring in the shroud

 

I Jb weld them in with the 2 part kwik-weld.

I do 3 or 4 spots and wait until the stuff is almost set up, set it on a glass table and look through from the bottom until the ring is equal in all the vents