OME, ready to buy.

After combing through this forum for hours when I'm supposed to be doing something productive at work. I have decided to replace this crappy rough country lift with the following.

OME 886 springs and NS90000 struts up front

CS047r leaf springs in rear.

I'm pretty sure my wife has my winch sitting under the Christmas tree, and my front has already sagged to the point where I'm rubbing constantly with this rough country lift

I currently have 22.75 from center of hub to fender well. I believe that is at least a half an inch lower than when I installed it.

I'd like suggestions on the best place to buy

Thanks,

 

Got mine from Toytec without any issues. Heard good things of Down South Motorsports too. Both Vendors on here. They give a TW discount.

 

HeadStrong off-road

 

Headstrong http://www.headstrongoffroad.com/headstrong-kits-tacoma-05-6-lug.html
Link to the page not the lift so navigate for it

 

Thanks, I like the prices on headstrong. hopefully I pull away with the win in my fantasy league. that will fund most of this. haha

 

OP. I would recommend staying away from the 886 coils, unless you are going to be running an heavy bumper and winch combo. Even then, I would suggest going some 887s and a 10mm Enhancer kit. Much better ride, and less chance of other issues compared to the 886 coils.

 

Looked at the pricing on the LR control arms. not too shabby. I see this company getting a lot of my hard earned dollars.

 

I just put on ome 887s if you need pics.

 

Thanks for the input, I am adding a winch, but I'm not adding a full bumper, I'm going to buy a hidden winch mount I saw somewhere in this forum. I think it was only 90 pounds at max though. I need to clear 285x70 r17s. do you think I should do 885's and add the 1/4 spacers if needed?

 

885s with the 1/4" spacers will give you about 2.5" of lift with the winch on the front.

 

What is your measurement from center of hub to fender well?

 

What is the difference between 885's and 887's?

 

They are the same spring rate, but the 887s are a little longer coil.

 

Haven't measured yet I will in a bit I'll attach a ciuple.pics I'm easily 3 to 3 1/4 higher up front

 

Truck looks good! ^^

 

alright, I'm sold.

What size tires are you running and did you have rubbing issues?

also, what struts did you go with?

 

I'm 24" up front both sides and 24.5 in the rear

 

285 75 16 just,trimmed that plastic piece under the front bumper and removed my front flaps I'm running bilstein 5100s set at 0

 

Also,have my alignment sheet to my,caster is a little low nothing horrble tho tie and camber are in the green.