Waterproof Fuse and Relay Boxes - RFRM (10 relay) & RTMR (5 Relay) no Blue Sea/ SPOD

Well I'm not in any rush for mine right now, so I might make a move next week when I get paid and have you send me an invoice, then send it whenever you get to.

 

My distributer contacted me today as well as the carrier/ Distributer asked If I was going to be home, since they were shipping me a package on a certain day. I had 2 orders outstanding with them though. Not sure if it is the replacement LAGE order or a smaller one I made immediately after to cover the loss for current client orders.

 

yes. These should work. Beauty is you can Invert them. Meaning Flip the plate. There is enough vertical clearance in the engine bay to clear these without issue.



I will have them in hand in a day or two and will verify size.

 

kenaiking, where did you get those switches? The ones for in front of the shifter?

 

WILL DO MAN!
I have a bunch of Stainless Steel hardware Im going to use on the ones that will be seen, if it weren't so much to ship a little box I could ship you some, they even have SS lock nuts as well

I planned on doing mine about the same as yours, plating inside and out of the roof rack, then mounting another bracket to the outside to mount the light. Do you get any wobble (up and down) in the light driving?

Sorry to thread jack, but I did just get paid and its time to order!!!

 

I got them from air on board. They fit perfect and were easy to wire. Only down side is they dim backwards because of the shared ground in the wiring.

I was able to install all the switches by just removing my heater controls. It's tight to get your fingers behind there but it is doable. I also relocated my aux in and USB to the glove box to make room for the extra switch.

You can push the blanks out pretty easy with your fingers but the actual switches take a bit more effort. A dental pick is helpful as well.

http://www.aironboard.com/online/toyota-replacement.html

 

Actually I just got the SS bolts and nuts so I'm good , plus I live in Mexico so shipping would be expensive, but thank you!

I just sent you the email, let me know if I can help you with anything else.

And no, I didnt get any jumping of the bar, but DO consider welding the pipe with the internal plate (the one that goes on the inside, check my email) and doing the holes by putting the holes together (dont forget the locking washers for the nuts!!!)

 

Hell dude, life always takes precedent.

Speaking on my own behalf, your needs > mine.

 

These are the OTRATTW Carlin style switches and backs. I just do not have the plate faces on them.

 

LOL, is that for TacoDane or me? Im ready to order now

 

If its for me, I'm ready with funds.lol

 

Damn those look amazing

 

I'm cutting down the small plates so they are the smaller perimeter plates only

 

These are for tacodane. Spoke to JIM, and he is shipping the rest out first thing next week when the rest of his stock is in.

 

I was thinking the same., but they still look great none the less.

Woohoo

 

I'm going to eat something and then break out the heavy machinery to cut these bad boys.

 

FYI- 6 colors are in the works for the switch backs. Still usable just not the individual colors I was hoping for for my writeup on these boxes. Wanted to be able to tell people which wire goes to which switch harness relative to the relay.

Little at a time.

 

Chop saw worked good to hack mine up.