FS: ESUSE LED Foglight Kits - direct fit 2012+ Tacoma

$128 shipped



These foglights have been used by many credible retrofitters and installers including myself, TRSAndrew, Lightwerkz, etc etc.

See for yourself below!

http://www.hidplanet.com/forums/showthread.php?57160-Esuse-LED-fogs-lightwerkz
http://www.lightwerkz.net/photo/output-pictures/cree-led-fog-light/


The ESUSE LED Fog Lamp is an OEM-grade fog lamp housing that utilizes LED technology. It replaces the entire factory fog lamp housing.


With the newest projector optics, the light is directed perfectly at a very wide angle, with a clear cutoff line. These lamps have been tested for SAE compliance, and are DOT and ECE compliant.


The design features projector optics, directing light from genuine Philips Luxeon T LEDs, binned at a 5000K pure white color. With a constant current drive circuit, built-in passive heatsinking, and input power smoothing, the fog lights will work perfectly for years.


The entire housing is weather-sealed, and features a GORE patch to allow for depressurization of the housing when the light heats up and cools down. These design characteristics are all similar to the quality and thought that goes into OEM headlamps, which is why we are proud to call these "OEM grade."

3 year warranty.

 

Want

 

Must have

 

hmm..i've pm'd, but never got a response. is he still around?

 

PM'ing you

 

Got your pm. Thanks!

 

Probably not. Your best bet would be to add yellow film if you want the lower temp color.

 

Yeah I'm not a fan of that look either. Thanks Ryan

 

Sorry if this is a silly ?, when you say direct fit, you do mean plug and play??

 

Direct fit, no mods. Plug and play.

 

Sweet, thanks.

 

Subd

 

Subd

 

up up

 

so these fogs come with a 5000k led bulb installed ?

 

Yes they come with 5000k LEDs already installed. You swap the entire housings.

 

how easy is the install ?? just plug and play ??

 

CREDIT = member: cemuscg

A little modified version of the install.

Now on to the install...

1. Mark the wall in front of the truck (of OEM foglight cutoff) with painters tape so that you can check the new lights alignment once installed.


2. Remove 10mm bolts under the bumper (2 per side). These can also be removed with a philips screwdriver.


3. There are only 2 philips screws holding each fog light on, the inboard side tabs fit into holders without screws.



4. Go ahead an insert the wires into the plug for each light. Red on the new light goes to green on the harness. Remember that this is a 2014, you may want to double check your wires prior to inserting them into the plug... Just insert the prongs into the stock harness and test the light, if it doesn't work, swap them around. Once it's in, they are a pain to remove!



5. The wire loom is going to be somewhat longer now. My OCD would kill me if I didn't zip tie it up.



6. Check your alignment once you have both sides installed. If you need to raise or lower the beam, use the adjustment screw on the bottom of the light.


7. Reverse

 

Top of the morning.

 

Light output and cutoff pics?