16" aftermarket rims

Got any pics??

 

Mine are 16"x8".

 

They are not on the truck yet, but here is a pic...

 

Tirerack.com

 

Another set of 16x8 Dick Cepek Torque with 4.5" backspacing on mine.

 

I likey. Where did you get them?

 

Installed my method 301 and no clearance issues. It is close but as long as you use the flat weights you will be fine.

 

Model: Vision Manx 398

Size: 16x8
Offset: 0mm
Backspacing: 4.5
Bolt Pattern: 6x5.5
Center Bore: 110mm

I got some bore spacers from Amazon for like 5 bucks in order to take the 110 down to the Tacoma's size.

I run 285/75/16 Hankook ATM tires. With a full 3" of lift in order to minimize trimming.

 

I'm thinking of getting these wheels in the same size for my stock taco. I have 265/70 tires. I'm looking for the bore spacers; are they aka "hubcentric rings" that friction fit into the bore, or did you get spacers that attach to the lugs?

Thanks

 

Just purchased these. They look awesome!

 

Other than just back spacing, the design of the wheel itself can make a difference. The stock wheels on my Pro fit, but I'd bet you couldn't fit a fat credit card between the wheel and the edge of the caliper. One member on here said that he likes the older 6 spoke factory wheel that came on 1st gen Tacos (came in 15 & 16" size)...he has 16's and they hit the caliper on the 2nd gen Tacos. I have a set of 2000 4runner wheels that are going on my Tundra, but in a year or so when the Tundra gets sold I'd like to put the 17's back on the Tundra and keep the 16's for an OR set for my Pro. I have seen them on a second gen, but will have to see if they clear or not. I assume they will fit as they clear my 1st gen Tundra. Seems the most common clearance issue is not always a diameter thing but can be the edge of the caliper hitting the back side of the wheel in some cases.

 

Which ones?

 

Nice!

 

I have some 16" XD Hoss going on mine next week. Can't wait!