Measurements needed - 2nd gen 4 cyl

Anybody have a front and rear hub to fender measurement for a 4 cyl DCSB, 2nd gen PreRunner?


Mucho appreciated.

 

I currently have about 400 lbs in the bed, I could go get the measurement but it would probably be off(let me know if you want that number too), if nobody else responds on this by Saturday, I can get you an unloaded measurement, that's when I'm dropping this load off.

 

Saturdays good! Thanks bro.

You stock config? Wheels and tires, suspension?

 

Yes, 2,200 miles on it, stock everything, steel wheels.

 

Thanks bro!

 

No problem. to hold you over

With 400lbs of wood pellets in the bed
Center of hub to fender
F: 21"
R: 20.75"

 

Sounds about right. Reason I'm asking, I didn't bother to measure before installing anything, so I'm not sure how much lift I'm seeing on my setup. Just trying to ballpark. My front with .85 of preload is 22" and my rear with possible 1.5-2" of lift is 23.5" unloaded.

 

Unloaded w/ a half tank of gas
F: 20.5
R: 21.5

 

Great, thanks bro.



RyRy, less than 90 of my truck in the entire state of CA IIRC. If it was that easy, I'd do it.