Tire size

With a 3in leveling kit can I get 18x10 rims under my truck? If not what size can I fit under it?

 

285/70/17 and 285/75/16 seem to be popular sizes.

 

Do you think I could get 18's under it?

 

Mudflaps will have to go and you probably have to do some minor trimming. What size tire were you thinking of 285/60r18?

 

What tire/brand were you looking at? That's helpful too.

(Welcome, I see you're local-ish to me )

 

probably gonna have to trim the inner fender, bend the pinch weld over. and probably do a cab mount chop.

Thats if you actually plan on flex the truck n stuff a tire or two.

 

Nitto mud grapplers prolly 285/70/18

 

your probably going to have to go 285 65 18 and you should be fine with minor trimming

 

If I got 285/60/18 what all would I have to trim?

 

Yes.

 

What would I have to trim? Just inner fender well?

 

I had to trim the inner fender, the fender flare at the bottom by the mud flap, remove the mud flaps, CMC and I still have to flatten the pinch weld and possibly trim some more.

 

Okay.

 

Thank you so much for the help!

 

Anybody on here have 35/12.50/17 mud grapplers
Did you have to cut and what do they look like. I'm looking for a good stance and somewhat of an offset

 

What if I went with 18x9?

 

For a 35 inch tire on any 3 inch lift be prepared for a lot of trimming banging down the pinch weld trimming fender flares etc you'll have a lot of rub if you don't trim right on any 35 inch tires

 

What size rim?

 

Rim at that point doesn't matter the size of the tire will be 35inches regardless so you'll so close to the same trimming if it's a 20 or 16 inch rim personally I don't like bigger than 17s on tacos they're not big enough in my opinion to run bigger rims than that but to each his own

 

18x9 with a 4.5" BS, you will need some inner plastic trimming running 285/65/18. Personally, less rim-more rubber more ideal for sidewall protection, bead protection during low psi applications, and much more available tire choices and cheaper pricing.