1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

265/75/16 tires on a 2.7 4x4

Discussion in '2nd Gen. Tacomas (2005-2015)' started by JBecker, Feb 19, 2015.

  1. Feb 19, 2015 at 12:42 PM
    #1
    JBecker

    JBecker [OP] Well-Known Member

    Joined:
    Feb 11, 2015
    Member:
    #148416
    Messages:
    874
    Gender:
    Male
    Virginia
    Vehicle:
    2015 AC SR 4X4 2.7 Manual
    While I'm waiting for my truck to come in I'm trying to research some mods for it. The truck is a 2015 SR trim AC 2.7 4x4 5MT. My plan is to get a set of Fox 2.0 coil overs and stock size Fox shocks in the rear right off the bat. I only really want to level the truck and get the good ride characteristics the Fox suspension gives.

    Now I plan on getting the BFG AT KO2's, but I'm unsure if I should just get them in the stock 245/75/16 or if I should go up an inch to 265/75/16 tires. Will these tires fit without rubbing? I don't want to do any cutting or modifications other than the coil overs.

    Any first hand experience with this tire size on one of the 4 cylinder trucks is appreciated. Pics would also be great.
     
  2. Feb 19, 2015 at 12:49 PM
    #2
    JBecker

    JBecker [OP] Well-Known Member

    Joined:
    Feb 11, 2015
    Member:
    #148416
    Messages:
    874
    Gender:
    Male
    Virginia
    Vehicle:
    2015 AC SR 4X4 2.7 Manual

    I wasn't sure if there was a difference with the stock wheels. Width, offset, etc.

    So does this mean the 265/75 will fit without issue?
     
  3. Feb 19, 2015 at 12:50 PM
    #3
    cgs2k2

    cgs2k2 old man

    Joined:
    Apr 24, 2010
    Member:
    #35923
    Messages:
    3,247
    Gender:
    Male
    yes sir

    *beat me to it
     
  4. Feb 19, 2015 at 12:55 PM
    #4
    JBecker

    JBecker [OP] Well-Known Member

    Joined:
    Feb 11, 2015
    Member:
    #148416
    Messages:
    874
    Gender:
    Male
    Virginia
    Vehicle:
    2015 AC SR 4X4 2.7 Manual

    Thanks. The coil overs go between 0-2" of lift. I figured to level the truck I'd probably be less than 1" of lift on the front as the 4 cylinders seem to be pretty level.

    If they do rub I could just crank the front slightly higher and run a 1" block out back and not have an issue.

    I don't want to lift it much, just enough to clear a slightly larger tire. I'll be taking it on mild trails fairly often, but nothing crazy. I also don't want it too high because I still want it to be easy to get dirt bikes in the bed.
     
  5. Feb 19, 2015 at 5:00 PM
    #5
    Desert Dave

    Desert Dave Member

    Joined:
    Jul 5, 2014
    Member:
    #133319
    Messages:
    16
    Gender:
    Male
    Apple Valley, Ca.
    Bilstein 5100's at .85 over stock, Relentless fabrication aluminum skid plate.
    I'm running 265/75/16 Tera Grapplers, (load range D) on my 2014 Reg.cab 4x4 with 5100's up front set at .85 height, stock in back. Zero rubbing, and the 2.7 pulls them just fine.
     
  6. Feb 19, 2015 at 5:16 PM
    #6
    JBecker

    JBecker [OP] Well-Known Member

    Joined:
    Feb 11, 2015
    Member:
    #148416
    Messages:
    874
    Gender:
    Male
    Virginia
    Vehicle:
    2015 AC SR 4X4 2.7 Manual

    Thanks for the info. How do you like those Nitto's?
     
  7. Feb 21, 2015 at 4:02 PM
    #7
    Desert Dave

    Desert Dave Member

    Joined:
    Jul 5, 2014
    Member:
    #133319
    Messages:
    16
    Gender:
    Male
    Apple Valley, Ca.
    Bilstein 5100's at .85 over stock, Relentless fabrication aluminum skid plate.
    So far so good....I'm prob. not a good reference to use, my first Tacoma, my first set of any AT's on a truck. They get me where I want to go though, (Mojave desert trails and mountains).
     
  8. Feb 21, 2015 at 4:20 PM
    #8
    tomwil

    tomwil Well-Known Member

    Joined:
    May 15, 2014
    Member:
    #129887
    Messages:
    8,025
    Gender:
    Male
    East Coast USA
    Vehicle:
    2014 Reg Cab 4x4
    Just curious why no one considers the 265/70R16, which has the same circumference as the 245/75R16, and the same width as the 265/75R16?

    With the 265/70R16, you would have no rubbing, and your speedometer would still be accurate.
     
  9. Feb 21, 2015 at 4:28 PM
    #9
    JBecker

    JBecker [OP] Well-Known Member

    Joined:
    Feb 11, 2015
    Member:
    #148416
    Messages:
    874
    Gender:
    Male
    Virginia
    Vehicle:
    2015 AC SR 4X4 2.7 Manual

    I think you answered your own question. If I'm going to lift the truck, and plan on replacing the factory all season tires with larger ones, I'm gonna go up in size a bit rather than just width.

    Also the difference between 245/75 and 265/75 isn't that much. And in my experience the factory speedometer reads fast and going up an inch in tire size usually puts the speedo right on when I confirm with a gps.
     
  10. Feb 21, 2015 at 4:38 PM
    #10
    nd4spdbh

    nd4spdbh Well-Known Member

    Joined:
    Oct 7, 2013
    Member:
    #114055
    Messages:
    14,607
    Gender:
    Male
    SoCal
    Vehicle:
    13 DCSB TRD OR v6 Auto
    you wont rub with the 265/75R16's


    that stated.... WAIT on the KO2's... the current 265/75R16's of the KO2's come in load range E ONLY.... thats a 53 lb tire which coming from the stock 245/75R16's is 20+ LBS PER TIRE HEAVIER....

    THATS A LOT of extra rotating mass.... stick with something P rated or load range C and you will be much better off.

    Might have a look at the Hankook Dynapro ATM RF10's its only 39lbs.
     
  11. Feb 21, 2015 at 4:51 PM
    #11
    glwood6

    glwood6 Well-Known Member

    Joined:
    Jul 25, 2008
    Member:
    #8125
    Messages:
    2,487
    Gender:
    Male
    First Name:
    Gary
    Albuquerque, NM
    Vehicle:
    03 XCab Prerunner
    Bilstein 4600 shocks.
    Where are you planning to get the Fox shocks & coilovers?
     
  12. Feb 21, 2015 at 6:03 PM
    #12
    JBecker

    JBecker [OP] Well-Known Member

    Joined:
    Feb 11, 2015
    Member:
    #148416
    Messages:
    874
    Gender:
    Male
    Virginia
    Vehicle:
    2015 AC SR 4X4 2.7 Manual

    I'm actually leaning more toward the Nitto Terra Grappler for this reason. You can get them in a D range which would be better for the 4 cylinder.


    ToyTec. They have the coil overs for $799 and the shocks are $250 plus another $25 for the roost shields.
     
  13. Feb 21, 2015 at 6:58 PM
    #13
    nd4spdbh

    nd4spdbh Well-Known Member

    Joined:
    Oct 7, 2013
    Member:
    #114055
    Messages:
    14,607
    Gender:
    Male
    SoCal
    Vehicle:
    13 DCSB TRD OR v6 Auto
    those nitto's are still a heavy tire in load range D... 47.2 lbs.
     
  14. Feb 21, 2015 at 7:02 PM
    #14
    JBecker

    JBecker [OP] Well-Known Member

    Joined:
    Feb 11, 2015
    Member:
    #148416
    Messages:
    874
    Gender:
    Male
    Virginia
    Vehicle:
    2015 AC SR 4X4 2.7 Manual

    Hmm, I'll have to do some research on lighter tires. I could always just do the suspension first and wait for a lighter BFG to come out.
     
  15. Feb 21, 2015 at 7:18 PM
    #15
    MKW

    MKW Well-Known Member

    Joined:
    Nov 27, 2007
    Member:
    #3623
    Messages:
    3,272
    Gender:
    Male
    Murrells Inlet, SC
    Vehicle:
    2014 RC 4x4
    OME 3" lift MK6 wheels 285 Fierce MTs & 4.88s!!
    Get Kelly TSR in 265 load C. My brother has them and loves them.
     
  16. Feb 21, 2015 at 8:21 PM
    #16
    nv529

    nv529 Well-Known Member

    Joined:
    May 9, 2014
    Member:
    #129448
    Messages:
    910
    Gender:
    Male
    First Name:
    Nick
    Metro Detroit, Michigan
    Vehicle:
    2006 Long Travel Taco, 2010 FJC, 2018 F250 Alumiduty

    where did you find the tire weight?
     
  17. Feb 21, 2015 at 8:23 PM
    #17
    nv529

    nv529 Well-Known Member

    Joined:
    May 9, 2014
    Member:
    #129448
    Messages:
    910
    Gender:
    Male
    First Name:
    Nick
    Metro Detroit, Michigan
    Vehicle:
    2006 Long Travel Taco, 2010 FJC, 2018 F250 Alumiduty
    Toyo open country A/T II P265/75R16 weigh 41 pounds.
     
  18. Feb 21, 2015 at 9:23 PM
    #18
    JBecker

    JBecker [OP] Well-Known Member

    Joined:
    Feb 11, 2015
    Member:
    #148416
    Messages:
    874
    Gender:
    Male
    Virginia
    Vehicle:
    2015 AC SR 4X4 2.7 Manual

    That's not too bad.

    Also I should point out I'd prefer to stick with a US made tire rather than a Chinese one.

    Looks like Goodyear makes the DuraTrac in a C1 load rating as well. I hear good things about that tire. They are 45 pounds.
     
    Last edited: Feb 21, 2015
  19. Jun 14, 2021 at 11:23 AM
    #19
    GermanTickler

    GermanTickler Active Member

    Joined:
    Sep 27, 2020
    Member:
    #342087
    Messages:
    32
    Gender:
    Male
    Vehicle:
    2009 toyota tacoma
    Toyo open country good for snow?
     
  20. Jun 14, 2021 at 8:09 PM
    #20
    stickyTaco

    stickyTaco Fuck Cancer

    Joined:
    Dec 11, 2012
    Member:
    #92904
    Messages:
    5,940
    Gender:
    Male
    First Name:
    Zack
    Reno/Tahoe
    Vehicle:
    '12 DCSB TRD-OR
    Fox/Dakar with Relentless goodies and stuff
    Some are severe snow rated and some aren't so pay attention to which ones you purchase. The A/T II didn't have the greatest rating but the A/T III is too new for ratings on tire rack. Maybe head over to the tires forum and search there?
     

Products Discussed in

To Top