What Have You Done To Your 2nd Gen Tacoma Today?

Hm.. that is good to know. I've been wanting that exact bumper but wasn't sure if my AAL's would be able to take it since I have a toolbox loaded with shit too. May bump this up a few notches on my wish-list.

 

I've got the Dakar's with overload so my ass-end sits up high. I went this route in anticipation to rear plate, topper, gear, etc.

 

Same boat. I beefed my dakars in prep for the Pelfrey rear I just got (installing this weekend). I also have a shell and plan on a safari basket for the top. Id rather be over prepared than under prepared.

 

Fixed it for you

 

Found a place to carry my tin foil hat, ordered rigid sr-m spot lights and cbi ditch mounts, and blue sea fuse holder.

 

That's a good place for it! Readily available

 

Giggle'd at the tinfoil hat.

 

It counts if it was after midnight right??

Had to make my own adapter to go from the compressor to the standard compressor fittings. Should hold pretty well.


Laid out everything on the skid and was able to snag some pics...

 

Put new shoes and wheels on

 

x2

 

Liked the old ones more personally

 

I hear ya. They did look similar to yours. These look better to me and SCS has some top notch wheels that have always balanced amazing for me. No more than 1.5 oz on any of the wheels

 

Maybe with the hybrid bruteforce front bumper that's about to go on in a week or two you will change your mind

 

i have 9oz on a couple of my fuel offroads

 

Got my pelfreybilt gear back from powdercoat. Installed the lights and shackles. Waiting on my m8000-s to finish things up. Considering mounting 3-4 of my IPF 968 lights inside the hoop.

 

When I ordered my Icon suspension, I requested 700lb springs. However, they were delivered with 650lb springs. Well, finally got them and installed today.

 

DOes it feel really stiff?

 

What fog lights are you using?

 

Was installing the CV axle bushing but didn't have the removal tool, so I just climbed in and did it with hand tools.