Wyoming B.S. Thread

Yep, after hearing him talk about it, I am putting it back on the list. I am gonna go swing by and talk to him over break and see if I can't set up a time to discuss some questions i still have. 60k a year with housing is not all that bad sounding. Graduate school may also happen now too. Unsure about it but its almost necessary.

Did you get Jons truck running yet!?

 

Cool you guys have some relating stories of recent

Sounds awesome Gage. The disappearing hours comment is true, sometimes you get paid in sunrises

Monte, I cant wait to see Johns truck for reals one day!

 

Yea I didn't think I'll do graduate school. Just too hard to get in at the place I wanna go..

But sweet! That sounds like a good job to me. I guess it'll depend on the location you end up too.

It's freaking beastly man..stoked to see it done too.

 

I made the 1st major step towards 35s today......

 

Growing a set of balls? Congrats! Bout time. Lets go have a beer and celebrate!

 

Not sure you can talk smack there engine swap, front locker, winch, full skids, ham radio stud.
But I'm down for beer. Installing wiring of projectors now.

 

Jax is 10 weeks this week. Two others on my flickr if you want to see more.

1 by sconniehailer, on Flickr

 

I have never said I would do an engine swap! Or full skids, or ham radio. Front lockers are just to pricey haha.

In other news, can't make this rear bumper work to save my life. First, doesn't look like tyler accounted for the 1.75'' because it hangs 1/2'' past where I cut. Then this damn swing out won't go on because the pieces don't want to slide in.

 

BFH

 

What? It's lower gage?


Damn Jax is huge! Look at those paws!

 

No, it hangs past from where the fenders were cut for 35s

 

Ooooooooohhhhhhh

Just cut it. I'll reweld it later.

 

There are other issues right now too but I am waiting to here back from Tyler to see of they are common

 

What's wrong with the swingout.

 

Going off the instructions it sounds like you put the bearings in the hinge, then seal off the bottom, stick it on and put on the castle nut and cotter pin. The smallest bearing won't slide through to its place. I put them all on the spindle piece on the bumper and placed the swing out on and it just won't slide.

 

Pretty sure the small bearing goes on after the swingout goes on. Show me a pic of the parts so I know what kind of spindle it is.

 

I can tomorrow, its dark and I got tired of it haha.

 

Here is someone elses.

 

Bottom bearing, swingout, top bearing (it's upside down in the pic)
Is there a dust cover for the bottom bearing?
If so, put the bottom bearing and dust cover in the swingout first

 

Yeah I believe there is a dust cover. There is a piece that fits in the bottom to seal it off.