DenverMojo's Build Thread!

Added bed lights from TacoDane this weekend. Been wanting to do this for a while, glad I finally got around to it. Top switch is the master on/off wired through the power line.
Bottom toggle switch is a dual throw switch wired through ground. It's wired for tailgate pin switch / always off / always on.

Normally, I'll have it switched to use the tailgate pin switch for ground. So, lights go on anytime I open the tailgate.

 

How are the seat covers doing after 3 years? How are they in the summer?

 

Hey there! I put these seat covers on my Tacoma and my wife's Forester. Three years into it and the driver side seat on both have seen better days. I developed a tear on the driver seat cover. That tear got worse and worse over time. The forester seat cover is starting to wear at the seams.

All in all, I feel like they are a little bit of you get what you pay for. they have done a good job of protecting my seats, but the fit and finish has been average. They were much less than most options at the time. Next time, I think I'd probably just fork over the money and do Katskinz leather covers.

 

Thanks for the information! I think I will go a different route then.

 

any info on the bed rack? and where to buy it