Extending front ABS lines

Not sure if I need to extend but I worry about it. I am running a 3+" lift. Hub to fender on driver and passenger is 23.5" maybe more depending on where I park, it's hard to find flat land here, sometimes it's 25" others 23". I worry about full droop.

I'm running:
OME 887's
Bilstein 5100's at 0
Toytec .5" driver
Toytec .25 passenger

How do I, or is there a part to extend the ABS line?

 

The ABS line is simply a two wire sensor. If you need/want to extend for peace of mind then inside the engine bay on the inner fender well there is an electrical connector on each side. You can simply wire in an extension there to feed more length down to the sensors at each wheel. I tore mine apart when lifting the body and that is how I found this connector. It ripped the wires out of the back of the plastic fitting.

 

ABS wheel sensor wire or are you talking brake lines?

you can extend both, abs wire will need to be built, brake lines can be bought.

3 inch lift should not impede on the wheel sensor wire, you may need to pull a bit to get the angle right, but, not to worry as there is a small amount of excess.