1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Walbro 255 install failure

Discussion in 'New Members' started by Cleo, Feb 11, 2013.

  1. Feb 11, 2013 at 7:15 PM
    #1
    Cleo

    Cleo [OP] New Member

    Joined:
    Feb 11, 2013
    Member:
    #97321
    Messages:
    1
    Gender:
    Male
    Ventura ca
    Vehicle:
    06 4wheel dr v6 supercharged 6 Spd
    Urd 3 in exhaust. Walbro 255 fuel pump/ filter kit. Trd supercharger. Urd urd 2.8 pulley
    Install went fine. After the kit was installed properly the trucks check engine light came on and several codes came up which all relate to air fuel ratios. In the instructions it says to unplug a relay. I'm wondering if that affected TRDs reflash for the TRD supercharger. The truck runs like crap now, I'm scared to drive it until I figure out the prob. Anyone else have this issue? Any help would be appreciated. I'm a new member and got a lot of useful info from other posts but haven't found anything related to my problem. Thanks y'all
     

Products Discussed in

To Top