1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

2WD third gen drive shaft replacement

Discussion in '4Runners' started by jrg24, Apr 21, 2015.

  1. Apr 21, 2015 at 10:52 AM
    #1
    jrg24

    jrg24 [OP] Well-Known Member

    Joined:
    Mar 28, 2015
    Member:
    #151944
    Messages:
    219
    Gender:
    Male
    I have been reading through several forums relating to driveshafts and most seem to be about 4wd vehicles. Everyone mentions that the splines have to go back in the same place or it will cause a vibration issue. I assume this only related to 4wd vehicles?

    I have to replace my driveshaft. I cannot think of any reason why I cant just slide it in, bolt it up, and be good to go. Has anyone replaced theirs? Is there any specific requirements that I need to consider when I do the replacement?
     

Products Discussed in

To Top