Emu Leaf Pack Help

I just finished installing the Old Man Emu leaf pack. Love the new look; however, one side is 1/2" taller than the other. Is this common? Are there fixes out there?

 

Have you driven the truck yet? There might be a bit of binding in the bushings that will quickly work out with a even just a test drive.

 

Just drove to my local tire shop. Measure again when I get home with the new shoes on.

 

Not sure about OME but some Tacoma leaf packs are left or right specific due to the fact that the Tacoma battery, fuel tank and driver are all on the left side and they tend to lean left.

 

This...the Dakars are side specific i believe.

 

Isn't that a nice lil fun fact. Any idea how to tell which side is which?

 

Not on 2nd Gens they aren't

 

Ok my mistake. It's been a while since I installed mine.

 

OP , did your leafs have a + , 0 , or - on them ?

 

ARB/OME is only showing 1 part number for the rears on the 2nd Gen.

The 1st Gen Taco had Left & Right specific leafs.

 

2nd Gen Dakars are not side specific

 

High side has a + low side has a 0.

 

^^^ This

Mine both are "+" but don't have any lean. Who knows?

 

Mine were both +. I flipped them over side by side and without a load they were exactly the same. When I installed them, my front end was still 1/4" lower on the driver's side and the rear was the same. I haven't measured again since I cranked the coil another turn.
If your truck wasn't that way with the last springs (I'm betting it was) you can always install a shim on the driver's side.

 

Gotcha, I have 887's with the trim packer up front.

 

mine are both "+" installed a week ago, and have 3/4" difference with the driver side being lower...
rzaucha has your issue been solved ? if so what all did you do ?... if you don't mind me asking.

 

Plus side should be on the driver's side if the other is a 0 or -.

 

Driver side may be lower because your front driver side is lower thus lifting your rear passenger corner.