turn the key and nothing...HElP

Replaced Battery, battery terminals, solenoid contacts, still nothing. Accessories work fine, starts when it wants.

 

Yep, checked grounds. I am going crazy

 

if your accessories are fine then check the starter. give it a couple knocks with a wrench and see if it starts. If it does then it is your starter

 

Tried knocking the starter, I also brought the starter to get checked, checked out fine.

 

Did you check your the starter relay or fuses?

 

No, where is the relay?

 

I'll go check fuses now

 

ours will be similar
https://www.youtube.com/watch?v=iWbZmi-Wsac

 

MAF might be dirty or the electrical connection could be loose. Also check the main ground, it'll be some large white wires with a black tracer on the inner fender wall on the right or left side. Also check the starter relay and other components in the fuse block. They might be melted.

 

Fuses are fine

 

I don't have a meter, but, if the relay is bad, would it work intermittently, maybe I should just get a new one

 

I pulled the key switch out, and turned it with a needle nosed pliers, still nothing

 

Your problem could also definitely be your ignition switch/module at this point

 

What's the "MAF"?

 

I only said that because he said it starts when it wants to. But usually a bad/dirty maf results in a start-stall condition

 

The ignition switch module? Is that the 1" x 1" brass/plastic cube right under the key switch?

 

NEW CLUE! I got it to start. Only by putting it in neutral and slightly pulling back on the shifter. Isn't there an adjustment somewhere?.. To make it start in park?

 

Can the neutral safety switch be adjusted? Or do you have to replace it

 

Ah neutral saftey switch. Good deal. I say just replace it if you can

 

Here is the adjustment procedure from the 1999 Tacoma FSM: