Bed bolts

so there are six bolts that hold my 96 bed to the frame. Looks like there needs to be a bolt and washer for 2 that mount closest to bumper? Looks like there are threads in the rails but not for rear 2? Looks like a nut should go in there to hold bolt.

You can see rear U mount I am talking about below...near the wiring harness.



Thank you for looking.

 

Yes you are correct, the two rears use a special bolt.

Bolt: 64189-35030
Washer: 90201-12061

I can't seem to find the nut part number, but any dealer should be able to tell you.

The 4 regular bolts: 90119-12254

 

The 4 bolts go into a nut that is welded inside the strut. I had to cut mine out on 2 and wondering if anyone might know the size?

 

I need to replace the ones on your 1st gen as well. They're pricey from Toyota, wondering of anyone has the specs for a hardware store replacement. (I can buy them elsewhere for less than what their shipping costs.)
Thanks everybody!

 

sub'd for part #s

as for the rear two,, I never put them back in but never had an issue

 

On my replacement bed, the 2 middle bolt holes were badly rusted, bolts won't tighten up.
So I'm going to need the 2 back ones for sure, just to secure the bed. Especially when I'm on those back country roads. (It also helps to have the lighting system grounded thru these bolts.)

 

I have a set in good condition. Where are you located?

 

Crossville TN

 

I dunno what shipping would be but I would send them to you. Lots of folks here have helped me out in the past and I would pay it forward.