Bed power port reset

does the 110 outlet in the bed have a reset? I was going to try to run a small heat gun off of it but I'm worried what if it trips it is there a trip and reset button?

 

I am not aware of one on mine. Check the manual. I'd think it would pop a fuse if there was too much draw.

 

It has in internal cut off, if i remeber usung my vac. It shuts down and resets after it cools down.

 

Ok just wanted to be cautious thanks.

 

Let us know what you find out.

 

It also says in the manual that if to much draw there is a fuse located inside the interior fuse block location.

 

Ok so this is the first time I used it so the truck was running and I pressed the button and both green and Amber lights came on. It seemed to run the heat gun ok but it did seem to blow a bit softer then at the house. I got the job done and that's all that matters!! First use was a success!!

 

As long as you don't blow a fuse, the inverter will trip and cut-off but it will reset after a while. I have had this happen a couple times.

 

It's a 400 watt inverter. I'm certain that if you're heat gun was manufactured in the last 30 years it has a voltage and an amperage rating on it. volts x amps = watts.

 

Yeah, it just shuts off for a while then resets. Had this happen a time or two before.

 

Also remember many inverters are not true sine wave output like your AC sockets in your house. That might be why your heat gun ran different. I would suspect the ones in trucks ate just a basic inverter. Many motor dvices will either run different or not at all.