One piece coverking install question

hey guys so I ordered black and red neoprene coverking custom seat covers for my 2015 taco. The covers came in one piece though not two like the install video shows. There is some plate between where the seats meet so I can't put the clips on through the top and bottom. Anyone know how to remove this plate? This is what the site is telling me but I can't figure it out. My fingers don't pass through the middle something is blocking it. See the pictures in the boxes.



IF YOU DO NOT HAVE ACCESS THROUGH THE SEAT CUSHIONS:If you are unable to place your hand through
the middle of the seat cushions and see your fingers emerge from the other side, your vehicle may have a flap that is secured by metal rings to proceed. For more information please visit:

support.coverking.com/entries/27416734- Seat-Flap-Adjustment

SEAT BACK AND BOTTOM ONE PIECE?

Some vehicle seat designs require the backrest and seat bottom covers to be joined. After
the covers are slipped over the seat back and bottom, there is a special accommodation that you push between the cushions. For more detailed information please visit: . support.coverking.com/entries/29491150-How- Do-I-Install-One-Piece-Seat-Covers?

 

You might get better feedback if you didn't post your question in the build thread, good luck OP

 

Sorry this is only my second post ever. New to the site I will try and find another place to put it. I just new it was second generation.