1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

One horn went out, swapped with Honda CRV horn

Discussion in '1st Gen. Tacomas (1995-2004)' started by ThunderOne, Aug 16, 2015.

  1. Aug 16, 2015 at 9:25 PM
    #1
    ThunderOne

    ThunderOne [OP] Well-Known Member

    Joined:
    May 20, 2009
    Member:
    #17473
    Messages:
    10,043
    First Name:
    Mitchell
    Nashville
    Vehicle:
    1ST GEN OR GTFO
    Toyota NERD
    One of my horns went out so I decided to do a swap. I went with a 2003 CRV horn, made in Japan. It is very JDM sounding (yo), and is loud and annoying as hell and will get anybody's attention.

    Install is simple, all you need is one small female connector that plugs into the pin on the Honda horn, a small section of 20 gauge wire, and a male connector to go into the Toyota connector. The horn is grounded when bolted to the frame. The existing bolt can be used and no relocation or fabbing is necessary.

    Follow the same procedure for both the low and high note horns.


    CBDE6E31-E1D5-4A19-BA45-8BC41E7935F2_zps_097d719a14dda862f3a7d191307dcfde23ecde16.jpg
    0BB7C3B2-ABF3-4607-B97D-CCF70E166F90_zps_5fba2003980ba847b80adab4e41f7498ffdb3d15.jpg
    DDCCA727-4F78-4FA6-B6AE-662D7CB676F2_zps_51ba286529d10d1ed24702a29376b64e365a4033.jpg
     
    Last edited: Aug 18, 2015
    Caligula likes this.

Products Discussed in

To Top