AZ BS Thread 2.0

My artiates are worked in perfect. Wear them Damn near everyday.

 

Well its going to be interesting to see how this goes. I like my tie up high ankle boots allot! So getting use to no ankle support will be weird for a while

 

But they look so much better. Did you get round toe or square toe?

 

The thin long toe

 

Just fucking around. Square toe

 

Mine are square they seem to be more comfortable with a little more toe room.

 

Exactly! The air force juans

 

Good man. Square toe is the way to go.

 

Been reading through the few days of posts.......Thanks for all the support guys. Means more than you know!

 

Lot more roomy. Its nice

 

This literally made me laugh out loud.

 

I am telling you I bet its the Diff Bearing. These trucks don't lose wheel bearings usually till over 100K. And I have methods as long as you have the lug centric lug nuts you should be fine.

 

But on both sides with only 24k?


EDIT: also how do I tell if I have lug centric lugs?

2nd EDIT:: is there a way to tell if those are bad?
Like on my 2wheel drive you jack up the front an grab top and bottom of the wheel an try an shake it.

 

Have you seen the picture?

 

I also have the 6spd my passenger seat only started shaking after I put aftermarket rims on my truck that weren't hub centric I would highly suggest the rings Moose1988 is talking about also I know the Falken wild-peak AT's you have are not that great I've had numerous go 'out of round' on my work trucks

 

Yeahh I'm dead trying to find a place here in SoCal that I can pick up a set before I head home so I can see if that's what it is

 

@iJonny whats the top burn out light? I thought that the traction control button shut it off

 

Traction control. It will turn itself back on if you take the key out. Hold button for 5 seconds to turn off.
#RTFM

 

Ahhhh so if I just push the button while truck is on it doesn't disconnect I have to hold the button 5sec?