Keyless entry wiring

I just installed power door locks and a keyless entry system on my standard 2 door Tacoma. Everything went well and it is working great. I want to hook up so the parking lights flash and the horn chirps when the locks are activated/deactivated. I cannot figure out what wires control the parking lights and the horn. Does anyone know what wires to use for this.

Thanks so much.

 

wish I had a good diagram, but I can't find it right now. Main fusebox there will be a green wire running to the fuse for the parking lights that's a positive polarity wire. If you have a negative polarity out put from your keyless entry system, you could tie to the green wire that feeds any of the dash lights that come on when you turn your parking lights.

The horn is a green/red wire, negative polarity, also routed to the under dash fusebox.

You could always run a pair of wires up into the engine bay and tie into those circuits at the horns and the parking lights themselves.

 

http://www.the12volt.com/installbay/forum_posts.asp?tid=130004

 

This is exactly what I needed thanks so much. I noticed that the link was to a 2010 it should be the same on the 2014 correct.

 

Probably so - if not, the12volt is a good place to ask questions.

 

Just wanted to thank you guys for this info. Just hooked up the horn and parking lights and it worked out great. One small issue I noticed is the lights do not flash if they are set to auto mode. Any ideas how to work around this? Also does anyone know which wire is for the dome light? Dome light is not a big deal to me but if I can find it I can hook it up to go on when I unlock the doors.

 

you could try the positive parklight see if that works.


domelight is negative