1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Single Cab Interior Panel Question

Discussion in '1st Gen. Tacomas (1995-2004)' started by Ritchie, Jan 7, 2016.

  1. Jan 7, 2016 at 5:27 AM
    #1
    Ritchie

    Ritchie [OP] Well-Known Member

    Joined:
    Dec 24, 2012
    Member:
    #93649
    Messages:
    1,931
    Gender:
    Male
    San Diego (North County)
    Vehicle:
    RC Step side Pre-runner
    2.7 w/auto, 4WU 3 link, F & R Diamonds, ARB's F/R w/ Yukon 5.29's, Inchworm 4.7 Lefty, Deavers, ARB OBA, Schrockworks up front.
    Without damaging them, I need to remove the plastic panels that house the seatbelt retractors.

    Can anyone out there share some insight?

    Thanks.
     
  2. Jan 7, 2016 at 6:44 AM
    #2
    frizzman

    frizzman Well-Known Member

    Joined:
    Sep 25, 2013
    Member:
    #113212
    Messages:
    5,349
    Gender:
    Male
    Pittsburgh, PA
    Vehicle:
    04 XCab 4x4 TRD/OR
    OME 2.5,Tundra 17s,Falken Wildpeak AT3W hitch w/ 7-pin, ARE cap, JVC HU w/BT, HID/LED lights
    most of the time you have to take the back panels off first, then the sides are mostly held on by clips
     

Products Discussed in

To Top