28" Light bar need help

How to remove grill to get behind to drill holes to mount light bar. I have been looking and can't find a thread any help. Don't want to break anything.

 

There are 2 silver screws on top. On the outer edge each side there is a black push fastener. Just use a screw driver and pop the top up then pull it all out. On the bottom just under a long flat black plastic are 4 more push pin fasteners. Remove them. Then grab the grill and gentle pull up and out.

 

https://www.tacomaworld.com/threads/30-light-bar-install-easier-than-you-might-think.406194/

 

Thank you guy's for the posts. They are a big help. Will let you no when i get it in it's very cold here now and i don't have a garage. Everyone on this site is great always willing to help out thanks again.

 

Need more help with push switch. My wire harness has a cheap on/off with 3 wires red white black. Getting a push switch that has 4 wires 1 black 1 greenw/yellow stripe and 2 red w/ yellow stripe don't know how to hook it up. I am not that good with this. if someone has some easy pictures to follow that would be great. The cheap switch black wire is the ground white wire goes to relay and red wire goes to battery. Plus the relay has another black and red wire.Do i hook up 2 red and 2 black to battery?

 

www.caliraisedled.com

 

This is for the mictung switch on Amazon

 

Don't know brand got it online no brand name. The switch is Mictuning with harness the new one is OME replacement

 

This was the switch that came with the opt7 wiring harness. Black/ground. White / Power in. Blue / power out. Hope that helps

 

Thanks the new switch has 4 wires 1 black 2 red w/ yellow stripes and 1 green w/ yellow stripe only 3 wires coming out of my harness.

 

On the switch there is a 4th for dash light which will illuminate and dim with your dash lights. I really couldn't see the switch at night anyway so I just choosed to not hook it up

 

ok thanks