bilstein 5100s 2013 tacoma

https://youtu.be/AYhE2GfxQF8

 

Looks good, aside from the vertical videoing. Did you add a leaf or anything in the back?

 

It just has the 5100s on the back with no leafs added to it , sorry about the vid lol i recorded it wrong

 

If you get a little free time, let's see what the whole truck looks like from the side. I'm going to be adding 5100s all around in a few weeks. Curious to see how it looks without adding anything but 5100s to the rear. I have always loved the looks of the regular cab Tacomas, by the way.

 

Thank you man , today i will take some pictures on a flat road so you can see how it looks

 

It looks front high to me. If it came that way from Toyota I'd bet you wouldn't be satisfied with it.

 

Im probably gonna do a 1 inch block on the rear

 

Have you measured the wheel gaps yet? Curious how close the front and back are.

 

No man i havent measured them yet i might do it tomorrow and let you know

 

Thanks I have a set waiting to go on and can't decide what setting to go with. 85 or 175

 

I would be willing to bet his measurements are dead level. I agree with a previous post that said he looked slightly nose high. Mine was like that before my AAL. The measurements came up dead even on all 4 corners. I think the rear fenders are cut slightly higher into the rear quarters, than they are in the front. This would explain why, with even center of hub to fender measurements on all 4 corners, it would still be slightly nose high.

When mine measured level @ the fenders, I measured cab to ground, at the front of the cab, and at the rear. The rear sat slightly lower.

 

Iowa10 this is how the truck looks on a flat surface