1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Crowsfoot type for efi ect sensor?

Discussion in '1st Gen. Tacomas (1995-2004)' started by kgw, Mar 10, 2016.

  1. Mar 10, 2016 at 2:44 PM
    #1
    kgw

    kgw [OP] Well-Known Member

    Joined:
    Jul 9, 2012
    Member:
    #82260
    Messages:
    343
    Gender:
    Male
    First Name:
    kgw
    SoCal
    Vehicle:
    99 PreRunner
    140 amp alternator, Big 3 upgrade, Ultimate Headlight Mod, Trans Cooler
    I managed to change this sensor (thanks to those who pointed it out), but the connector plastic would not allow any of my sockets to reach the nut. I got it tightened just enough with a 19mm open end wrench and pliers, but I'm getting a seep after engine shutdown. I see two types of crowsfoot: normal and flare nut. Which is preferred? Meaning: which will fit on the sensor best, if at all? :annoyed:
     
    Last edited: Mar 10, 2016

Products Discussed in

To Top