Air On Board wiring

Hey guys,
I just purchased the opt 7 32" Light bar, and an air on board switch for the blanks on the left side of the steering wheel. They both have yet to come in, but for now I am wanting to get some help on the wiring. I'm not very electrical savvy at all. Can someone help me out on how to wire the whole set up, and what do with the AOB switch?

Thanks

 

what compressor


just like this for the relay but replace the lights with the compressor

 

use 10g wire for the power and ground for the compressor. for the rest of the wires 16g is fine

 

Air-On-Board is the switch manufacturers.

 

Sorry to say, but I'm confused So what I think I know is that from the light bar I plug in the harness, then from the harness plug into the battery, then run the rest through the grommet into the cab, but the AOB switch has a lot of wires already on it, and it is supposed to light up. What do I do with the wires on the switch?

 

I'm sure they have a diagram on the site. How many pins? 5? One is power. One is accessory. The rest are just ground and possibly headlight tap

 

The diagram I posted for the lights is perfect. Only thing different is the switch